GFCVG may be printed in most solvent and eco-solvent printing systems such as: Mimaki JV3, Mutoh Toucan, Vutek, Nur, Roland Versa Camm, Mutoh Value Jet, etc.

Ink coverage of up to 400% is recommended. Suggested heater settings: pre-heat 60° C, print heat 55°C. Due to the heavy weight of the canvas, feed rate through the printers may not be consistent, causing prints to differ slightly in size from print to print or from the expected size after RIP’ing. To optimize print quality, printers should be set for highest print quality. Color profiles for GFCVG, GFPOLY, and GFPHOTO are interchangeable.

The imaging layers of the material will be consistent, yielding repeatable image performance, but due to the material being a natural base, white point and fabric weave can vary from lot to lot of material.

After printing, material should be permanently attached to a rigid board or frame with staples or tacks. Using glue or pressure sensitive adhesives is not recommended, as this does not prevent the material from natural environmental shrinkage over time. When the material shrinks, the adhesive may fail, causing edges to curl and possible delamination. Shrinkage may also cause spacing between paneled job not mounted properly. All edges of the material should be affixed to the mounting surface to prevent the edges from curling. All canvas is susceptible to edge cracking if stretched improperly.

GFCVG has a high degree of water resistance due to the use of solvent inks. The water resistance may be affected if the recommended ink saturation level is exceeded.

Liquid laminates, such as Clearstar’s laminates, are compatible and provide excellent surface protection. Always pretest the liquid laminate for compatibility prior to using. For more information, log onto their website: www.clearstarcorp.com. It is not recommended to overlaminate with pressure sensitive laminates because they do not have complete contact with the surface of the textured canvas. Delamination can result.

Unimaged material should be stored at 72°F (+/-5°) for no more then 1 year. After use, the roll should be stored in its original packaging in the poly bag for no more than 1 year.


GFCVG may be loaded into the printer in roll or sheet form. Before loading canvas, the cutting mechanism MUST be turned off or removed. If you do not turn off the cutter, the printer head may jam during the cutting sequence. Once the canvas is loaded, and before printing, advance the front edge 2 to 3 inches past the printhead to avoid head strike. After a print is completed, manually cut the print from the roll and remove the roll from the printer.